1、輸入特性(INPUT CHARACTERISTICS): a)輸入電壓(Input Voltage): ????額定電壓(Nominal Voltage):100~240Vac ???調整范圍(Variation Range):90~264Vac b)輸入頻率(Input Frequency): ????額定頻率(Nominal Frequency):50~60Hz ???調整頻率(Variation Frequency):47~63Hz c)輸入電流(Input Current): 在額定輸入電壓100V~240V時輸入電流小于1A (The maximum input current shall be less than 1A at 100~240Vac input) d)待機功耗(Maximum Energy Consumption in NO-Load) 在額定輸入電壓100V~240V時待機功耗小于2W (The input power shall be less than 2W at 100~240Vac input.) ?2、輸出特性(OUTPUT CHARACTERISTICS): a)額定電壓(Rated Voltage):DC42V±0.2V b)額定電流CV模式(Rated CurrentCV mode):2±0.2A c)轉燈電流(Turn lamp current):200-400mA d)波紋和噪音(Ripple And Noise): 輸出端并0.1uF與10uF電容,限制示波器帶寬20MHz時,測得紋波*:300mv ?Output ripple voltage is 300mvX p-p measured methods:Performed by 20MHz bandwidth in oscilloscope.Applied 0.1uF ceramic capacitor and 10uF electrolytic capacitor across output connector terminals Measured at the end of DC cable. ? e)啟動延遲時間(Turn On Delay Time): 當輸入115Vac和輸出*負載時,*啟動時間為2S。
2 second Max. At 115Vac input and output Max. Load. f)上升時間(Rise Time): ?當輸入115Vac和輸出*負載時*時間為40mS。
40mS Max. At 115Vac input and output Max. Load. g)保持時間(Hold Up Time): ?當輸入115V和輸出*負載時,最小保持時間為5mS。
5mS Min. At 115Vac input and output Max. Load. h)效率(Efficiency): ?當輸入100Vac和輸出*負載時,最小80%。
80%Min.At 100Vac input and output Max. Load. ?當輸入240Vac和輸出*負載時,最小81%。
81%Min.At 240Vac input and output Max. Load. i)過沖(Overshoot): ?在電源開啟或關閉的時候,*15%。
?15%Max.When power supply at turn on or turn off. 3、保護功能(PROTECTION REQUIREMENT): a)短路電路保護(Short Circuit Protection): 該電源供給器在短路解除時,能恢復正常工作。
The power supply will be auto recovered when short circuit faultsremove. b)過流保護(Over current Protection): 過流故障排除后,電源將自動恢復正常工作。
???The power supply will be auto recovered when over current faults remove. 4、環(huán)境要求(ENVIRONMENTAL REQUIREMET): a)工作溫度(Operating Temperature): ????0℃~ 40℃,滿載,正常工作(Full load Normal operation)。
???0℃to40℃,Full load Normal operation. 儲存溫度(Storage Temperature): -20℃to85℃,帶外殼(With package). b)工作濕度(Relative Humidity): ????5%(0℃)~90%(40℃),72小時,滿載,正常工作 ???5%(0℃)~90%(40℃)RH,72Hrs,Full load Normal operating. 5、安全及EMC要求(SAFETY AND EMC REQUIREMENT): a)安全(safety):符合CCC CE FCC KC標準(CCC CE FCC KC compliant) b)高壓(DIELECTRIC STRENGTH): ???測試方法按下面接線圖 (Primary to secondary): ?1500Vac/5mA/60s. ? ? ? ? ? ? ? 標簽: ? ? 深圳市電動車充電器 ? 深圳市電動車充電器廠家

廣東 深圳市深圳市電動車充電器廠家
供應36V10AH電動車充電器